Navigation:
System Configuration Sensors > Configuring Sensors > Calibration - General > Calibration - Using Synergy >> Default Calibration Values
Default Calibration Values
All Hanwell Sensors/Transmitters come with default calibration values which are created during installation.
•Over the years, as Sensors/Transmitters are calibrated, these values will change.
Each Sensor/Transmitter is installed with a default range of values. In the example above, the Calibration Points are +50, +25 and 0°C. See Figure 408 above.
•These are only suggested values and can be changed to suit the Users requirements.
The defaults can be re-loaded by clicking on the Set Default button which will display a warning dialog. See Figure 410 below:
Figure 410
You will be asked to confirm that you wish to load the default calibration values, select OK to confirm.